Citrus Machinery Aerosol Can Depalletizer
This is a single high depalletizer for aerosol cans that is available immediately. It was removed from service in good working order. The depalletizer includes the pallet lift and infeed track portions, plus a very nice overhead magnetic conveying segment.
Overhead can conveying option This machine has two vertical magnetic belt conveyor segments. The first elevating segment raises the single file stream of cans -exiting the mesh belt- to an elevation of approximately 12 feet. The cans are then routed on an overhead conveyor through the plant to a second magnetic "lowerator". This second segment lowers the cans to the 36" high elevation for the normal line operation. These vertical; magnetic belt conveyors are very expensive to buy new. I believe that a person could justify the purchase of this system, with these segments alone.
It is possible to re-configure the system to lower the cans to a 36" conveyor height directly from the main feed belt.
Priced to sell! FOB Midwest warehouse
 |
 |
 |
| View of elevated accumulation belt cans enter from the right side of this picture and exit tooward the top of the photo | View of pallet infeed conveyor track and pallet lift elevator | Merge section, where cans are routed into a single stream. At the far end is the vertical magnetic belt "elevator" that raises the cans above the floor, where they can then pass overhead through the factory to the aerosol line infeed. |
 |
 |
| This is an end view of magnetic belt elevator, looking toward the can mesh belt. It is important to note that this magnetic belt system does not need changeparts or adjustments between can sizes. the magnets grasp and center up the cans very nicely | This is a view of the magnetic belt "lowerator". The cans enter at the top and are transported down toward the floor. the cans pass through an outside loop and finally side-transfer onto the line infeed conveyor. |
Back to "Turntables, Container Feeders Depalletizers"