BGI 30' 4-lane Hot water test bath
36'4" overall length, including infeed and exit merge sections
This is a four-lane hot water bath that we constructed new in 1997. It was taken out of service (and replaced with a clean, low-time used bath) in early 2007.
At the time of construction in 1997, we used Alnico cast magnets and rails. We have removed these worn old magnets, and will rebuild this bath with new ceramic magnets encased in stainless steel - as is our usual magnetic rail construction method.
The tank and frame are in good condition, and by adding new magnetic rains and mechanical parts we can offer a bath that will be in excellent mechanical condition. A new drive motor and gearbox will be installed, along with all new shafts, sprockets guide rails and new Stainless Steel 7 1/2" tabletop chains. We can configure infeed and exit end conveyors to fit your particular layout.
 |
 |
 |
| View of infeed end of bath before rail removal | View of wier/skimmer tank on the infeed end of the bath | View of the stripped bath, ready for cleaning and rebuilding |
We can offer blow-off system, various bath heating options filters etc. Contact us for a discussion of your application
Back to "Hot Water Baths, Filters and Blow-Off"